If necessary, check in the menu of your router that new WLAN devices are allowed (MAC filter not active) and that they are allowed to communicate with each other. It is better to switch to secure WPA2 encryption. You have to convert your password before. If you still have the older, insecure encryption method "WEP", you must enter your network password as a hexadecimal format. In the current menu, go down to "Save/Restart" and press "OK" for the third time. Move the cursor key down to "Save WLAN Config" and confirm with "OK". The password will now be replaced by asterisks. Enter your network password/network password/network key. To integrate it into your WLAN network, proceed as follows: After starting the WLAN configuration, select "your" network. Check that "DHCP" is set to ON in the SCL menu and "Proxy" is set to OFF (other settings should only be made by experienced users). If you use the antenna base with cable for the WLAN antenna, screw the WLAN antenna onto the base. Select the DAC8 / MP3000HV as the playback device.Ĭheck that the WLAN antenna is connected. Connect the DAC8 / MP3000HV and turn it on. Double-click on the file' TplusAUSBASY-273.4.1. Download the latest driver version DAC8 or MP 3000 HV from the T+A website. Disconnect the USB connection from the DAC8 / MP3000HV to the MAC. kext (Attention! There is also the path: Library -> Extensions.). g.' Macintosh HD') under: System -> Library -> Extensions -> TplusAUSBAudio. Delete the installed driver by deleting the file' TplusAUSBAudio. If a driver is already installed, which does not work properly anymore, please proceed as follows: 1. If you haven't installed a driver yet, please refer to point 4. It can also happen that an already installed driver does not work properly due to a security update of the MAC operating system. Possible cause is that the driver required for USB HiSpeed mode is not installed or not installed correctly. ! Bitte beschreiben Sie das Problem in der E-Mail möglichst genau, damit wir es einfacher lokalisieren und beheben können ! Weg zum Senden der Geräte-Logs nicht möglich ist, kann in solch einem Fall die E-Mail durch Tippen auf die unten rechts eigeblendete Versionsnummer erstellt werden. Falls die MusicNavigator App gar keine Geräte findet und somit auch der o.g. Mit dieser Funktion können Sie uns eine E-Mail, senden, die für uns notwendige Daten der App und des Gerätes enthält, um Probleme zu erkennen und zu beheben. In der Sektion „Hilfe und Support“ der App finden Sie den Punkt „Log-Funktion“. Tritt der Fehler nach einem Neustart der App auch weiterhin auf? Bitte beenden Sie die App vollständig (wie das geht hängt vom Betriebssystem Ihres Tablets/Handys ab).ģ. Alternativ kann das Gerät auch für einige Minuten stromlos gemacht werden.Ģ. im Fall der Cala CDR/SR mit einem langen Druck auf die Ein/Auschalttaste-Taste der Fernbedienung wieder eingeschaltet wird). Tritt der Fehler nach einem Neustart des netzwerkfähigen T+A Gerätes immer noch auf? Sofern die Energiesparfunktion nicht aktiviert ist, wird der Streamingclient aus Komfortgründen nur neu gestartet, wenn das Gerät mit dem Power Taster an der Gerätefront aus- und wieder eingeschaltet wird (bzw.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |